the sun 3510 storage array

[Sherman, Mark]

hmmm, i think i see. 

are you going to connect to a host for configuration? you're aware you can 
give the sccli the device name + command for batch mode right?

such as 
# sccli /dev/dsk/c3t0d0s2 <command>

other than that, I'm not sure how to automate, as the other interfaces are interactive. 


-----Original Message-----
From: stan briggs [mailto:stan at stanbriggs.com]
Sent: Mon 5/10/2004 12:44 PM
To: ncsa-discussion at ncsysadmin.org
Cc: Sherman, Mark
Subject: RE: the sun 3510 storage array
 
mark,

well, i want to build a series of commands to configure the disk array. i
have a bunch of these that are going out and don't want to configure each
of these 'by hand'. i want to build a script and run it.

you have ideas?

stan
>
> why can't you use the sccli for this?
>
> -----Original Message-----
> From: ncsa-discussion-bounces at ncsysadmin.org on behalf of stan briggs
> Sent: Mon 5/10/2004 11:58 AM
> To: ncsa-discussion at ncsysadmin.org
> Subject: the sun 3510 storage array
>
> greetings,
>
> does anyone have any experience with one of these? i'm specifically
> looking for a command line interface so that i can automate the
> configuration process for these beasts. sccli is not what i'm looking
> for. neither is ssconfig. i want to be able to build an OS-level
> executable script that does all of the configuration stuff.
>
> later,
> stan
>
>
> _______________________________________________
> ncsa-discussion mailing list
> ncsa-discussion at ncsysadmin.org
> http://www.ncsysadmin.org/mailman/listinfo/ncsa-discussion
>
>
>
> _______________________________________________
> ncsa-discussion mailing list
> ncsa-discussion at ncsysadmin.org
> http://www.ncsysadmin.org/mailman/listinfo/ncsa-discussion