[TriLUG] more than one USB device

z zzd at trilig.org
Thu Feb 5 15:16:14 EST 2004


Did you 'eject' the first USB device? When using two Smartmedia cards, I have 
to umount the partition then eject the device before placing the second card 
in.

On Thursday 05 February 2004 14:19, Daniel Monjar wrote:
> I have a USB camera and now a USB 'DiskOnKey' device.  When I plug the
> first one in everything works as expected.  But when I plug the 2nd in I
> get 'disk not recognized errors':
>
> Feb  3 10:15:33 dam kernel: hub.c: new USB device 00:1f.2-1, assigned
> address 3
> Feb  3 10:15:33 dam kernel: scsi5 : SCSI emulation for USB Mass Storage
> devices
> Feb  3 10:15:33 dam kernel:   Vendor: M-Sys     Model: DiskOnKey
> Rev: 4.70
> Feb  3 10:15:33 dam kernel:   Type:   Direct-Access
> ANSI SCSI revision: 02
> Feb  3 10:15:33 dam kernel: Attached scsi removable disk sdd at scsi5,
> channel 0, id 0, lun 0
> Feb  3 10:15:33 dam /etc/hotplug/scsi.agent: sd_mod allready loaded
> Feb  3 10:15:33 dam kernel: usb-uhci.c: interrupt, status 3, frame# 302
> Feb  3 10:15:33 dam kernel: sdd : READ CAPACITY failed.
> Feb  3 10:15:33 dam kernel: sdd : status = 1, message = 00, host = 0,
> driver = 08
> Feb  3 10:15:33 dam kernel: Current sd00:00: sense key Unit Attention
> Feb  3 10:15:33 dam kernel: Additional sense indicates Medium not present
>
> But if I reboot the problem goes away.  How can I make the system forget
> about the first device without rebooting?




More information about the TriLUG mailing list