[TriLUG] Mandrake 10 again
trilug at daijin.nulluser.com
Thu Mar 11 12:53:02 EST 2004
--On Thursday, March 11, 2004 12:24:21 PM -0500 Brian Weaver
<weave at oculan.com> wrote:
> I've had problems with 10.0 on a dual system where I work. I installed
> everything and the kitchen sink because it was just a test system. It
> boots fine until it enables the swap, then it hangs right there. Nadda,
> I might have to track down a single CPU system to see if I have better
> Dan [trilug at daijin.nulluser.com] wrote on Thu, Mar 11, 2004 at 10:28:59AM
>> I've installed MDK 10 on my work PC and it is running just fine. A PC I
>> have at home is a different matter altogether. The home box is a dual
>> Pentium Pro 200. It has 384MB RAM and about 80GB of disk. It ran MDK
>> 9.2 with no problem, albeit a bit slow. MDK 10 installed last night
>> without a problem but when I boot it hits the 'uncompressing linux
>> kernel' and then reboots. It does this with the SMP kernel, the
>> non-SMP kernel and even the failsafe option.
>> Any ideas?
I had the same problem when I was looking at the MDK 10 release candidates,
I was hoping it was a beta thing. I'm going to play with the bios tinight.
I remember a while back having to change something at the bios level
dealing with the SMP stuff. If I figure anything out I'll post it.
More information about the TriLUG