[TriLUG] bandwidth provisioning using Linux or BSD?
Greg Brown
gwbrown1 at gmail.com
Fri Jul 18 10:21:50 EDT 2008
Aaron,
Thanks for the info. For some reason I had it set in my mind that iptables
was not capable of doing this kind of thing. Personally I'd prefer to go
with OpenBSD's pf. Can you provide a simple config for the following:
Assume: inbound and outbound bandwidth are both 10 meg 10/10
Gateway Interface: some routeable IP address
Internal network: 192.168.1.0/24
Internal Interface: 192.168.1.1 255.255.255.0
Server A: (connected to a L2 switch) 192.168.1.20
Server B: (connected to the same L2 switch) 192.168.1.21
I'd like to give both server A and server B 4 megs of bandwidth in and out
but I'd like them to be able to burst to the full 10 meg if bandwidth above
4 meg is unused.
Does that all make sense?
Greg
On Fri, Jul 18, 2008 at 10:14 AM, Aaron Joyner <aaron at joyner.ws> wrote:
> You can readily do all this with OpenBSD's pf or Linux's iptables/tc.
> The former is relatively easy, the latter a good bit more complicated.
> Both do the job, but I suspect since you're asking about competitors
> to a specific product (which I know nothing about), I assume you're
> expecting an http or at least ncurses style guided interface. Neither
> of my suggestions have this, although there are possibly wrappers
> around them, I'm not familiar with any of them. If you need
> suggestions with pf or tc, ask away!
>
> Aaron S. Joyner
>
>
> On Fri, Jul 18, 2008 at 8:24 AM, Greg Brown <gwbrown1 at gmail.com> wrote:
> > Hey all. I'm in search for a Packeteer-like device that is OSS, or that
> is
> > commercial yet runs on a Linux or BSD box (OSS greatly preferred). Like
> a
> > Packeteer I'd like to be able to define slices of available bandwidth to
> > specific IP addresses (X meg guaranteed to device x.x.x.x with Y burst if
> > bandwidth is available, etc) - and the complicated thing here is I'd like
> to
> > use IPv6 for host addresses. But the the IPv6 thing aside I'd like to
> know
> > what the OSS competitors to Packeteer are and if you have used any I'd
> like
> > to know what you thought of the product.
> >
> > Greg
> > --
> > TriLUG mailing list :
> http://www.trilug.org/mailman/listinfo/trilug
> > TriLUG FAQ : http://www.trilug.org/wiki/Frequently_Asked_Questions
> >
> --
> TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
> TriLUG FAQ : http://www.trilug.org/wiki/Frequently_Asked_Questions
>
More information about the TriLUG
mailing list