Thu Oct 27 00:06:51 EDT 2011
"The active-backup, balance-tlb and balance-alb modes do not
require any specific configuration of the switch."
Other modes do, like 802.3ad (LACP) - my preference when the switch has it.
----- Original Message -----
> The switch must then also support link aggregation. Does the blade
> backplane support that?
> On 11/10/2011 10:39 AM, David Black wrote:
> > Still not knowing what problem is solved/purpose served, the
> > following would probably do the job, while avoiding the reported
> > issues and confusion over what is supposed to happen:
> > 1. Set up a single layer-2 bonded interface, e.g. eth1 + eth2 ->
> > bond0
> > 2. Put the static IP address on bond0, and the secondary IP address
> > on bond0:0
> > This also has the benefit of allowing both addresses to share 2x
> > the bandwidth (depending on bonding mode of course), and the alias
> > going up and down won't bounce any physical interface.
> > Dave
> This message was sent to: David Black <dave at jamsoft.com>
> To unsubscribe, send a blank message to trilug-leave at trilug.org from
> that address.
> TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
> Unsubscribe or edit options on the web :
> TriLUG FAQ :
More information about the TriLUG