[TriLUG] Far, far OT: Thin-wall bushings

[Brian Henning]

That's right.  The bushing is inside the worm/motor assembly, filling the gap between the motor's 6mm shaft and the worm's 6.5mm bore.

The bot does control X/Y as well.  I'll put together a series of photos Real Soon Now (TM) that highlight all the parts and some of my future plans as well.

~B

-----Original Message-----
From: trilug-bounces at trilug.org [mailto:trilug-bounces at trilug.org] On Behalf Of Joseph Mack NA3T
Sent: Monday, September 22, 2014 10:57 AM
To: Triangle Linux Users Group General Discussion
Subject: Re: [TriLUG] Far, far OT: Thin-wall bushings

On Mon, 22 Sep 2014, Brian Henning wrote:

> Video!
>
> http://youtu.be/dr0-jbLeJ74
>
> Still working out some alignment kinks but the 'bot is obeying my 
> commands...*evil laughter*

neat. I take it the bushing you wanted fixed is at 53secs (the Z-axis presumably), although I can't see it (not surprising for a bushing).

Is your bot controlling the X,Y too?

Joe

--
Joseph Mack NA3T EME(B,D), FM05lw North Carolina jmack (at) wm7d (dot) net - azimuthal equidistant map generator at http://www.wm7d.net/azproj.shtml Homepage http://www.austintek.com/ It's GNU/Linux!
--
This message was sent to: Brian <bhenning at pineinst.com> To unsubscribe, send a blank message to trilug-leave at trilug.org from that address.
TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
Unsubscribe or edit options on the web	: http://www.trilug.org/mailman/options/trilug/bhenning%40pineinst.com
Welcome to TriLUG: http://trilug.org/welcome