<p><font size=3 face="Times New Roman">It might be easier to configure the switch at the other end to full Duplex 100mb...of course if you move the machine you have to reconfigure another switch port.</font>
<p><font size=3 face="Times New Roman">Shawn</font>
<p>
<br>
<br><font size=2 face="Courier New"><br>
> i remember this from a while back, but i think you can set the speed and<br>
> duplex at the module level.  to wit, in /etc/modules.conf:<br>
> <br>
> alias eth0 3c59x<br>
> options 3c59x speed=100 duplex=full  <---add this line<br>
<br>
i saw references to that on the 'net, but there isn't an entry for eth0 in <br>
my /etc/modules.conf - that just has:<br>
<br>
alias parport_lowlevel parport_pc<br>
alias usb-controller usb-uhci<br>
<br>
so i'm guessing the xircom-cb driver is compiled in, rather than a module.  <br>
not sure how to interact with it in that case.<br>
<br>
> dunno if this is supported by all nic modules but it's worth a shot.  <br>
> alternatively is it permissible to put the speed and duplex lines in <br>
> ifcfg-eth0?  never tried that but it seems logical.<br>
<br>
i'll give that a try.  i don't see any references for it, tho, so it may <br>
be logical but not realistic. :)<br>
<br>
                                                                                                                       lisa<br>
<br>
-- <br>
lisa lorenzin  |  lorenzin@1000plus.com  |  http://www.1000plus.com/lisa/<br>
of what avail is an open eye if the heart is blind? - solomon ibn gavirol<br>
<br>
_______________________________________________<br>
TriLUG mailing list<br>
    http://www.trilug.org/mailman/listinfo/trilug<br>
TriLUG Organizational FAQ:<br>
    http://www.trilug.org/~lovelace/faq/TriLUG-faq.html<br>
</font>